MasterCraft Wide Area Vacuum Especificações

MasterCraft Frequently Asked Questions (FAQs) What tips do you have for cleaning the outside and inside of my MasterCraft? Here are some ideas f

little alcohol as possible due to the moisture absorption problems. NOTE: Fuel additives and treatments, other than conditioners for moisture absorpti

temperature (140 degrees F to 190 degrees F) at low idle (600 to 800 RPM). Operate the boat in forward gear, accelerate quickly, but gradually, to pla

could cause serious injury or death, as well as damage to your MasterCraft that will not be covered under warranty. For the best engine performance an

should be used. Slings must be 6 inches wide by 20 feet long and a minimum of 3500 pounds capacity each. Use an eight-foot spreader bar on each sling

cushions in the boat when it is covered to take advantage of air circulation. Spray with a mildew repellent. While your vinyl is made to withstand the

Cleaning the windshield when needed is an important safety precaution. Your MasterCraft windshield is made of tempered safety glass and requires speci

Premium All-Purposes Cleaner is an exclusive product available only through genuine MasterCraft dealerships! What kind of wax should I use for my Mast

3. Check the hull drain plugs...make sure they are installed and secure. *To prevent a possible explosion, operate the blower for at least (4) minute

How do I change my propeller? 1. Ensure the engine is OFF and the engine safety starting switch is disconnected. Place the throttle/shift control le

1. Never put your arm, head or any other part of your body through the handle/bridle of the ski line, nor wrap the line around any part of the body a

boat is to be moored for a long period of time, use chafing protectors to protect the gel coat finish. Leave a little slack in the lines, allowing for

Replacing the computer (known as the MMDC) will erase the hours. It counts hours only when the engine is above 300 RPM. When equipped with a revision

the gauge indicates excessive temperatures during operation, slow down immediately and turn off the ignition. This indicates an engine problem that ne

moving too far from the helm. The lanyard is equipped with a hook on one end for attachment to your clothing or PFD, and the opposite end has a slide

Point Adjustment: In order to adjust the Speed Set Point in OFF Mode, first move the RPM/SPEED Mode selection switch to the SPEED position. Use the +/